LAST CHECKED:
October 29, 2026


Emil Rindell

Jonas Bryntesson

Henrik Andersson
PUBLISHED:
2021-06-08

Emil Rindell

Jonas Bryntesson

Henrik Andersson
2021-06-08
There are now many ways to model bent sheet metal in IRONCAD and to close corners there is a useful feature called Add Closed Corner.
In this specific case, however, we are dealing with a sheet metal part where the Add Closed Corner feature does not work to close a particular corner, since the two bends are not actually directly adjacent to each other. In addition, we create a clean 45-degree finish via the sketch on two Add Stock features.

By using the Relief handles on the bends, you can still easily close these corners as well with full control. There are also quite a few smart and simple shortcuts that speed up your work! Watch the video below to learn more about this.